Hi, Agree with Syed. I would suggest you to post this query in HP forums http://h30499.www3.hp.com/t5/forums/recentpostspage/category-id/proliant/post-type/thread ThanksRegards, Santosh I do not represent the organisation I work for, all the opinions expressed here are my own. This posting is provided "AS IS" with no warranties or guarantees and confers no rights.

Hi Guys, Power failure, lost a drive in my array, also, other disk seems damaged... It boots, but half way through WIndows Loading I get unmountable boot volume. Specs Windows 2008 R2 SP1 HP ML110 G6 HP P212 Raid Controller Everytime I boot to Windows Repair and try to load the driver, I get installation failed. Safe Mode, Last Good config, etc don't work. I'm stuck. Suggestions?

Please seek help from the HP partners as it might be the hardware issue. http://www.arabitpro.com

Hi, Agree with Syed. I would suggest you to post this query in HP forums http://h30499.www3.hp.com/t5/forums/recentpostspage/category-id/proliant/post-type/thread ThanksRegards, Santosh I do not represent the organisation I work for, all the opinions expressed here are my own. This posting is provided "AS IS" with no warranties or guarantees and confers no rights.

I doubt it is hardware. Windows actually boots to a certain point. I believe the file system is some what corrupt. However, I cannot load the drivers to actually do anything.

I'd boot into controller bios to check the condition of disk controller and physical/logical disks. If file system is corrupt then there may be nothing to do but restore from backups. Regards, Dave Patrick .... Microsoft Certified Professional Microsoft MVP [Windows] Disclaimer: This posting is provided "AS IS" with no warranties or guarantees , and confers no rights.

I finally got the drive loaded. Showing as raw... however, like I said, it boots half way through windows before it blue screens. Is there any come back from this?